 |
 |
 |
 |
Hot2Go® RGV40V12 25 GPM Gas-Vac Water Transfer System - 627cc Vanguard Engine
Capture and transfer up to 1500 gallons of water per hour from up to 350 feet away. The RGV40H is a powerful water capture and transfer system that is gas-engine driven and will recover water from over 350' away. The unique polyethylene separation tanks are non-corrosive, weigh less than others, and have full access to the inside for periodic maintenance with a quick lift-off lid. Open the large 1-1/2" valves to dump sludge / solids that collect at the bottom. Each separation tank has an automatic transfer system which pumps the water out to your bulk tank, landscape, or sanitary sewer where permitted. A debris filter and air filter protect both the transfer pump and blower from debris.
The RGV is a powerful water capture and transfer system that has a gas engine driven blower and will pick upwater from over 350' away. The unique polyethylene separation tanks are non-corrosive, weigh less than others, and have full access to the inside for periodic maintenance with a quick lift-off lid. Open the large 11/2" valve to dump sludge/solids that collect at the bottom. Each separation tank has an automatic transfer system which pumps the water out to your bulk tank, landscape, or sanitary sewer where permitted. A debris filter and air filter protect both the transfer pump and blower from debris.
|
RGV40H12
|
RGV40V12
|
Vacuum/Blower
|
Positive displacement blower creates vacuum through the included separation tanks
|
CFM / Vertical Lift
|
425 CFM / 14” Hg, 190” lift
|
Engine
|
688cc Honda, key start (GX630)
|
627cc Vanguard, key start
|
Fuel
|
Unleaded gas - Large 8 gal. fuel tank (50 state CARB and EPA Emissions Certified)
|
Vacumm Tanks
|
Qty 2) 26 gal corrosion proof, polyethylene, hexagonal tanks – 1½” sludge/solids drain
Air throttle valves to precisely control suction, Auto pump out, High water shutdown
|
Debris Strainer
|
Lift out, easy to clean strainer basket for pump protection, 12” x 9.5” deep, 1000 micron
Prefilter/solids/sand separation tank is available as an option (ATP36)
|
Tank Lid
|
Stainless steel, removable
|
Transfer Pumps
|
Qty 2) Transfer pumps connect to onboard 12v battery power
|
Power Requirements
|
Self-contained, no outside power needed
|
Inlet
|
Requires 2” diameter vacuum hoses (up to 350’), hot water compatible to 200°F
|
Outlet
|
2” diameter discharge hoses (up to 100’)
|
Recover & Transfer**
|
Up to 25 gpm with one or two pickup devices and total combined hose length of 350’
|
Temperature Limits
|
Up to 200° F
|
Contruction
|
Powder coated, steel frame, includes trailer/truckbed mounting holes
|
Battery
|
Not included, 650cca group 24 battery recommended
|
Weight / Dim.
|
425# plus Qty 2) 54# vacuum tanks. 44” L x 26” W x 34” H
|
Note: Not for use with waste streams with high foaming soaps.
*Specifications subject to change without notification and may vary due to ambient conditions.
**Not intended to be fully immersed under water, consistent air introduction at the pickup is needed to prevent hydraulicing.
|
|
 |
 |
 |
 |

|