 |
 |
 |
|
MorrHeat MH480B BiDi Waste Oil Heater
The MH480B 480,000 BTU Bi-Directional Waste Oil Heater allows Bi-Directional air throw and is the ideal unit for larger 6-8 bay garages and commercial shops. Capable of heating up-to 10,000 sq. ft. while consuming less than 3 GPH., it doesn't take much fuel to heat the desired area. This massive unit features a triple pass system designed with two stainless steel heat ex-changers, hinged swing out doors on both sides of the waste oil heater for easy ash removal, burns heating fuels, diesel fuels and used-waste motor oils.
Comes standard with the waste oil burner, on-board air compressor so you don't have to use shop air, fuel pump assembly, room thermostat and draft meter. With the MorrHeat line of waste oil heaters you save on hauling fees associated with waste oil removal, lower your heating bill and overhead through the winter months and increase profits at the same time.
|
Specifications
|
MH480B
|
|
Heater Rating
|
480,000 btu
|
|
GPH
|
3
|
|
Heating Area
|
10,000 Sq. ft.
|
|
Air Flow
|
100′ Ft
|
|
CFMs
|
8500
|
|
Flue Size
|
8"
|
|
Fuel Lines
|
3/8″ Copper Tubing
|
|
Fuel Types
|
Intended for operation with oil not heavier than ASTM D396 No. 2, used crankcase oil, used automatic transmission fluid (ATF), and used hydraulic fluid
|
|
System Draft
|
.02 – .06
|
|
Air Pressure
|
12-14 psi
|
|
Fuel Pressure
|
12-15 psi
|
|
Efficiency
|
84%
|
|
Min.Circ Amps / Max Fuse
|
20 amps / 20 amps
|
|
Run Amps
|
13.4
|
|
Power
|
120/240V (Not Dual V)/ 60HZ/50HZ / 1Ph
|
|
Dimensions
|
72" × 58.25" × 60.5"
|
|
Weight
|
850 lbs
|
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Perfect heating unit for larger 6-8 bay garages and commercial shops
- Capable of heating up-to 10,000 sq. ft. while consuming less than 3 GPH., it doesn’t take much fuel to heat the desired area.
- This massive unit features a triple pass system designed with two stainless steel heat ex-changers, hinged swing out doors on both sides of the waste oil heater for easy ash removal, burns heating fuels, diesel fuels and used-waste motor oils.
- Comes standard with the waste oil burner, on-board air compressor so you don’t have to use shop air, fuel pump assembly, room thermostat and draft meter
- Fuel Types: Intended for operation with oil not heavier than ASTM D396 No. 2, used crankcase oil, used automatic transmission fluid (ATF), and used hydraulic fluid.
This Item Does Not Contain Any CA Prop 65 Listed Chemicals
|
|
|
|
|
|
|
Owned & Operated in the U.S. since 1987
