Home > Fans, Blowers, Evap Coolers & Heaters >

MorrHeat MH480 Waste Oil Heater 480,000 BTU

MorrHeat MH480 Waste Oil Heater 480,000 BTU
MorrHeat MH480
 
Alternative Views:
: $15,495.00






Product Code: MH480

Optional 240V Voltage Available

240 Voltage
Optional Upgraded Metered Fuel Pump

MFPA: 		Metered Fuel Pump Assembly [Add $500.00]
Optional Upgraded Compressor

OBAC: 		On-Board Air Compressor [Add $750.00]
Optional Accessory

#CK8: 		8" Chimney Kit [Add $1,995.00]
Optional Tank/Heater Stand

#MHT350: 		350 Gallon Tank/Heater Stand [Add $4,495.00] more info....

#MHT550: 		550 Gallon Tank/Heater Stand [Add $5,495.00] more info....

Qty:  
Description Technical Specifications
 
MorrHeat MH480 Waste Oil Heater

The MH480 480,000 BTU Waste Oil Heater is the ideal unit for larger 6-8 bay garages and commercial shops. Capable of heating up-to 10,000 sq. ft. while consuming less than 3 GPH., it doesn't take much fuel to heat the desired area. This massive unit features a triple pass system designed with two stainless steel heat ex-changers, hinged swing out doors on both sides of the waste oil heater for easy ash removal, burns heating fuels, diesel fuels and used-waste motor oils.

Comes standard with the waste oil burner, on-board air compressor so you don't have to use shop air, fuel pump assembly, room thermostat and draft meter. With the MorrHeat line of waste oil heaters you save on hauling fees associated with waste oil removal, lower your heating bill and overhead through the winter months and increase profits at the same time.

Features
  • Perfect heating unit for larger garages and shops
  • The MH480 is our largest mode but is still an over 83% efficient waste oil heating unit that will heat up to 10,000 square feet and has an out-put of 400,000 BTU’s
  • While only consuming 3 gallons per our when operating, not much used oil is needed to keep the desired area warm while offering fast recovery times when opening and closing bay doors
  • Easy access to the fire chamber and heat exchangers make it very quick when cleaning or maintaining the MH480 waste oil heater
  • The combination of the MorrHeat waste oil burner and fuel pump assembly make for a very easy install and doesn’t limit the location of the heater according to where the fuel storage tank is in the building
  • When hanging the waste oil heater there are four all thread bolts conveniently located on the top of the heating unit for easy ceiling mounting
  • Burner Assembly - Shop Air System
  • Regulated Fuel Pump with Fuel Regulator
  • Fuel Types: Intended for operation with oil not heavier than ASTM D396 No. 2, used crankcase oil, used automatic transmission fluid (ATF), and used hydraulic fluid.

This Item Does Not Contain Any CA Prop 65 Listed Chemicals



Browse for more products in the same category as this item:

Fans, Blowers, Evap Coolers & Heaters
Fans, Blowers, Evap Coolers & Heaters > Waste Oil Heaters & Oil Boilers