In BusinessSince 1987
AZ, CA, DE, FL, GA, ID, IA, IN, MA, MD, MI, MO, NC, ND, NE, NJ, NY, OH, OR, PA, TX, WI
How it works
The DK1000 is welded to the panel surface using your Uni-Spotter Stud Welder. The dent is levered out using only the required amount of pull to leave a flat surface. The Dent Killer is then rotated around the weld to release the electrode, leaving a flat workable surface. Larger or longer dents are pulled progressively. Pulling is started at the center of a dent or end of a crease.