In BusinessSince 1987
AZ, CA, DE, FL, GA, ID, IA, IN, MA, MD, MI, MO, NC, ND, NE, NJ, NY, OH, OR, PA, TX, WI
Rated for cutting automotive grade sheet steel including trunk pans and floor boards, this TurboShear quickly attaches to a minimum 14.4-Volt, versatile cordless drill or maximum 7-Amp A/C drill. The unit's driveshaft inserts into a 3/8-in. (10 mm) or 1/2-in. (12.7 mm) chuck. An aluminum cast shear head and telescoping drill clamp offer one-handed control. The shear head may also be safely gripped for additional support. The compact molded polymer clamp adjusts for both length and width of any drill housing. A helical shaped foot permits easy left, right or straight cuts, and a 5-position head accesses cuts through profiles and into tight spaces. Clearance between the shear's cutting inserts may be adjusted as necessary for optimal performance in 16 to 26-gauge (1.52 - 0.46 mm) steel. The four-sided cutting inserts are designed to be rotated to maximize life before replacement. Insert cutting life is rated at 1,200-ft (365.76 m) in 16-gauge (1.52 mm) steel using four edges of inserts. Cutting life increases dramatically when averaged over cuts in a variety of steel thicknesses. Inserts are accessible without disassembly of shear head and are easily replaced on the job.