Power Probe III Circuit Tester with Lead Set Kit

Power Probe III Circuit Tester with Lead Set Kit - PP3LS01
Call for Special Pricing on this Item

Power Probe III
Maximum Voltage on Probe Tip: ± 200 Volts Relative to the Negative Battery Clip
Probe tip resistance to ground 130KO Computer Safe: 0.1mA floating tip. Voltage range: 12-24v

Power Probe Mode (Mode 1)
DC Voltage Measurement: 0 to 70 Volts (in 1/10th increments)
AC Voltage Measurement: 0 to 70 Volts Peak to Peak
(See Peak to Peak & Threshold Setting Mode 5)
Square Wave Input Response: 15 Hz to over 500KHz
Sine Wave Input Response: 35 Hz to over 250KHz
Continuity to Ground: Greater than 20K Ohms - Display is Blank Less than 20K Ohms: Display reads 0.0 Less than 2K Ohms: Display reads 0.0 and Green Led is On

Min (Mode 2) & Max (Mode 3)
Voltage Measurement: 0 to 70 Volts
Single Event Capture: Less than 200 Micro Second Pulse Width
Repetitive Events: Less than 1 Micro Second Pulse Width

Peak to Peak Mode (Mode 4)
0 to 70 Volts P-P Square Wave Input Response: 4 Hz to over 500KHz
Sine Wave Input Response: 4 Hz to over 250KHz

Peak to Peak Mode Threshold Setting (Mode 5) 0.2, 0.5, 1, 2, 5, 10 & 50 When the Peak to Peak Voltage on the Probe Tip exceeds this threshold then the display is Peak to Peak AC rather than DC.
Storage temperature: -40°C (-40°F) to 70°C (158°F)
Operating temperature: -20°C (-4°F) to 60°C (140°F)

Circuit Breaker
8 amp thermal response - manual reset
8 amp=No trip
10 amps=20 min.
15 amps=6 sec.
25 amps=2 sec.
Short circuit=0.3 sec.

AMP Ratings for Probes, Leads and Adapters
1, 3, 6' Leads: 30 amps Alligator Clip Lead: 20 amps
Male-Male Adapter: 30 amps
Female-Female Adapter: 30 amps
Small Piercing Probe: 10 amps 20-28 Gauge
Large Piercing Probe: 20 amps 8-18 Gauge
Power Probe Tip: 30 amps

300 volt RMS rating